The Pro Control
®
G3
Please read these instructions before using your Pro Control
®
G3
The Pro Control
®
G3 controls a variety of remotely operated dog training
equipment, including:
•
Several brands of bird releasers used for training pointing
and flushing dogs
•
Most brands of launchers used for retriever training
•
Several accessory items for retriever launchers such as
“retiring guns” and sound-making devices
The Pro Control
®
G3 is completely compatible with the Pro Control RL.
Transmitters from either system will operate receivers from either system.
Quick Guide
1. Charge the receiver approximately 14 hours before first use (the transmitter
has a 9-volt battery already installed – no need to charge). Insert the protection
plug in the charging jack of the receiver after charging.
2. Attach the antenna to the receiver and attach the transmitter lanyard, if desired.
3. Field-set the receiver as follows:
A. Select the transmitter dial number you want to use when you operate
this receiver.
B. Turn the receiver on by pressing the on/off switch – the on light will blink.
C. Press the SET switch on the receiver, and, within five seconds, press any
button on the transmitter.
D. Verify your setting, if desired, by pressing the upper transmitter button.
Be sure to put your hand over the horn – it's loud!
E. Attach the identification number to the receiver, if desired.
4. Attach the receiver to your training device accordingto the
manufacturer'sdirections.
5. Plug the cord from the training device into either output jack on the receiver.
Insert the protection plug in the unused output jack.
6. The middle transmitter button marked “L” operates the training device plugged
into the left output jack. The lower transmitter button marked “R” operates
the training device plugged into the right output jack. The upper button
marked “S” operates the sound.
7. You can set up two training devices close to each other and operate them with
one receiver by using both output jacks. If both training device cords won't
reach the receiver, an extension cord can be purchased from Tri-Tronics.
8. Pressing the TEST switch on the receiver verifies the hook-up of your training
devices by lighting the appropriate light on the receiver.
9. Turn the receiver off after use by pressing the on/off switch again. The setting
will be saved.
10. To change the station setting of the receiver, set it to a new transmitter
number by following Step 3.
Transmitter Components:
•
Transmitter
•
Lanyard for transmitter
•
9-volt alkaline battery (already installed)
Receiver Components:
•
Receiver
•
Antenna
•
AC charger
•
Two Nylatch
®
fastener sets per receiver
•
Spare charging jack protection covers
•
Set of adhesive identification numbers
(8 pages)
(15 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels